Miscellaneous - Cable - B-Move, DLU Lighting, Lucide, Max Studio, MM Spray, Polar, Sensor (31)

Sensor/actuator connection cable M12, A-coded, 8-pin, M12 plug straight - free cable end, PUR, black, unshielded . Flexible, silicone and halogen-free control cable with high mechanical strength. The cable is resistant to chemicals, hydrolysis and microb

shiverpeaks®-BASIC-S--Cable routing aid, nylon, 3 mm, 20 m Use the cable routing aid to pull your cabling through ductwork effortlessly. The nylon pull wire features an eyelet that the cable can be attached to, and a guide spring to make it easier to neg

Sensor/actuator connection cable M12, A-coded, 8-pin, M12 plug straight - free cable end, PVC-C, gray, shielded . PVC cable for use in control, regulation and sensor technology. Suitable for dry area use in packaging machines and assembly and conveyor te

shiverpeaks®-BASIC-S--Cable entry aid, nylon, 3 mm, 30m Use the cable entry aid to pull your cabling through ductwork effortlessly. An eyelet is provided on the nylon pull wire to fasten the cable to, and a guide spring to make it easier to negotiate ang

EBP-Earth Bonding Point, EPA suitable. For working in electrostatically protected areas (ESD workplace/ESD protection zone). Earthing point for mounting underneath the table top. EBP / Earth Bonding Point = A common connection point to which ESD control e

ESD discharge cable with integrated resistor. Spiral cable, 2x press-stud 10 mm/10 mm Length: 2.4 m

• Rated voltage: 250 V CAT II • Rated current: 2 A to 36 A (with 2,5 mm², fully unrolled) • Cable: 1,5 mm² • Plug: Ø 4 mm • Length: 50 m • Color: blue

Connecting cable, red/black, angled/straight 4 mm connection, for HIOKI multimeters from product series DT425x/DT428x or similar, CAT III 1000 V, CAT IV 600 V, 120 cm length

EPA suitable. For working in electrostatic protected areas (ESD workplace/ESD protection zone). For connecting the table and floor coverings and for connection to an earth potential. with 1 megohm safety resistor 2 push buttons 10 mm for mats or floor co

Sensor/actuator connection cable M12, A-coded, 5-pin, M12 plug straight - free cable end, PVC, gray, unshielded . PVC cable for use in control, regulation and sensor technology. Suitable for dry area use in packaging machines and assembly and conveyor te

Sensor/actuator connection cable M12, A-coded, 4-pin, M12 plug straight - free cable end, PVC, gray, unshielded . PVC cable for use in control, regulation and sensor technology. Suitable for dry area use in packaging machines and assembly and conveyor tec

Sensor/actuator connection cable M12, A-coded, 4-pin, M12 connector straight - free cable end, PVC-C, gray, shielded . PVC cable for use in control, regulation and sensor technology. Suitable for dry area use in packaging machines and assembly and convey

This cable gland has been specially designed for applications classified with ignition protection type ''E''. • Impact-resistant even in cold weather • High degree of strain relief • Large, variable clamping range • Long-lasting vibration protection

• Rated voltage: 250 V CAT II • Rated current: 2 A to 36 A (with 2,5 mm², fully unrolled) • Cable: 1,5 mm² • Plug: Ø 4 mm • Length: 50 m • Color: yellow

shiverpeaks® BASIC-S cable pull-in aid, nylon, 4 mm, 60 m Use the cable pull-in aid to easily pull your cable through a conduit. There is an eyelet on the GRP pull wire. The enclosed wire loop allows you to attach the cable to the eyelet. The screw-on hea

• Rated voltage: 250 V CAT II • Rated current: 2 A to 36 A (with 2,5 mm², fully unrolled) • Cable: 1,5 mm² • Plug: Ø 4 mm • Length: 50 m • Color: red

This Delock cable support is ideally suited to wall mounting for hanging laboratory cables or test equipment, enabling clear and tidy organisation. Specifications Cable support for wall mounting 2 x mounting holes Mounting hole diameter: approx. 8 mm 1

This Delock cable support is ideally suited to wall mounting for hanging laboratory cables or test equipment, enabling clear and tidy organisation. Specifications Cable support for wall mounting 2 x mounting holes Mounting hole diameter: approx. 8 mm 1

Earthing measurement cable, 4 mm connection, red, 50 m length, with cable reel

EPA suitable. For working in electrostatically protected areas (ESD workplace/ESD protection zone). For connecting the table and floor coverings and for connection to a ground potential. cable with 1 megohm safety resistor with 2 push buttons 10/10 mm p

Earthing measurement cable, 4 mm connection, yellow, 50 m length, with cable reel

The ÖLFLEX® CLASSIC 110 is a VDE-registered oil-resistant PVC control cable that can be flexibly used for a variety of applications. Flame-retardant in accordance with IEC 60332-1-2 Excellent chemical resistance Oil-resistant in accordance with DIN EN 5

• Rated voltage: 1000 V CAT III • Rated current: 2 A to 3 6A (with 2,5 mm², fully unrolled) • Cable: 0.75 mm² • Plug: Ø 4 mm • Length: 30 m • Color: red

Designed by women for women, our goal is to make you feel powerful and amazing from studio to street with the best fit and fabric.

ESD discharge cable with integrated resistor. Spiral cable, 3 mm press-stud to 10 mm press-stud Length: 2.4 m

• Rated voltage: 1000 V CAT III • Rated current: 2 A to 36 A (with 2,5 mm², fully unrolled) • Cable: 1,5 mm² • Plug: Ø 4 mm • Length: 50 m • Color: blue

Sensor/actuator connection cable M12, A-coded, 5-pin, M12 connector straight - free cable end, PVC-C, gray, shielded . PVC cable for use in control, regulation and sensor technology. Suitable for dry area use in packaging machines and assembly and convey

Sensor/actuator connection cable M12, A-coded, 4-pin, M12 connector straight - free cable end, PUR-C, black, shielded . Flexible, silicone and halogen-free control cable with high mechanical strength. The cable is resistant to chemicals, hydrolysis and m

• Rated voltage: 1000 V CAT III • Rated current: 2 A to 36 A (with 2,5 mm², fully unrolled) • Cable: 0.75 mm² • Plug: Ø 4 mm • Length: 30 m • Color: blue

shiverpeaks®-BASIC-S--Cable routing aid, nylon, 3 mm, 15 m Use the cable routing aid to pull your cabling through ductwork effortlessly. The nylon pull wire features an eyelet that the cable can be attached to, and a guide spring to make it easier to neg

TITANEX H07RN-F 3G1.5, black, wound, in a film bag, tested to VDE 0285-525-2-21 The high-quality H07RN-F cable is ideal for use in moving devices and electrical installations. Its versatile applications range from construction sites to industrial applic