Miscellaneous - DAHLE, General Electric (37)

Dry cleaning with replaceable felt

Flashing LED, 5 mm, yellow, Coloured diffused housing. Beam angle: 60° VF = 5 V (590 nm)/5 - 32 mcd GaAsP/GaP Manufacturer no.: L-56BYD

These LED reflectors by ALBS are no ordinary reflectors. They have been developed further, tested under laboratory conditions and are produced with outstanding attention to detail. They either increase or slightly dampen the colour reproduction value (RA)

These magnets are super practical for your home and for the office, allowing you to make creative ideas that seemed impossible a reality. Featuring super-strong neodymium magnets, Novus Dahle MEGA magnets make messages and objects stand out. Great for se

recessed mount with external reflector, chrome-plated ready mounted with yellow 3 mm LED Incl. washer and nut Features Installation Ø: 6.0 mm total height: approx. 13.5 mm Reflector head Ø: 6.8 mm Reflector head height: 2.5 mm Wavelength: 585nm yellow

• Large shavings compartment for longer use before emptying • High-quality steel cutting head for professional results • Sturdy desk clamp for secure attachment to the desk • Automatic sharpening cut-out for a perfect tip • Self-locking pencil retainer wi

• Large shavings compartment for longer use before emptying • High-quality steel cutting head for professional results • Sturdy desk clamp for secure attachment to the desk • Automatic sharpening cut-out for a perfect tip

The NA-SAVP6 chromax.yellow set is a fan accessory kit consisting of 16 yellow NA-AVP6 anti-vibration pads for up to 2 compatible 200-mm fans (see compatibility information). The anti-vibration pads, made from extra-soft silicone, reduce the transmission

recessed lampholder with internal reflector, chrome-plated ready mounted with yellow 3 mm LED incl. washer and nut Features installation Ø: 6.0 mm total height: approx. 17 mm reflector head Ø: 7.0 mm Reflector head height: 3.0 mm Wavelength: 588 nm y

• Basic board with white, lacquer-coated writing surface • For use with drywipe whiteboard markers • Magnetic writing surface • High-quality extruded aluminium frame with plastic corners for maximum stability • Lined board rear • Practical 30 cm tray for

• Basic board with white, lacquer-coated writing surface • For use with drywipe whiteboard markers • Magnetic writing surface • High-quality extruded aluminium frame with plastic corners for maximum stability • Lined board rear • Practical 30 cm tray for

LED with low power consumption, 2 mA. 5 mm, yellow-coloured housing, diffused Beam angle: 60° (590 nm)/0.8 - 3.2 mcd Manufacturer no.: L-53LYD

• Integrated cutter for a perfect tip • Automatic sharpening cut-out for a perfect tip • Sturdy plastic enclosure for long service life • Two measuring devices for writing or drawing points • Integrated cleaning plug for a clean lead point • Suitable for

12 x felt strips, replacement for DAHLE 95099 wiper

• Sturdy tripod easel with three fixing screws for firm standing • Infinitely variable height adjustment to optimum writing height (up to a total height of 187 cm) • White lacquer-coated, magnetic metal board in a sturdy aluminium frame for writing on wit

• Sturdy tripod easel with three fixing screws for firm standing • Infinitely variable height adjustment to optimum writing height (up to a total height of 187 cm) • White lacquer-coated, magnetic metal board in a sturdy aluminium frame for writing on wit

• Large shavings compartment for longer use before emptying • High-quality steel cutting head for professional results • Sturdy desk clamp for secure attachment to the desk • Automatic sharpening cut-out for a perfect tip

DIN A4 laminator with two heated silicone rollers Reliable lamination for permanent protection against moisture and dirt Two heated silicone rollers Heating time: 3 - 5 minutes Cold lamination possible Lamination in photo quality Working speed: 250 m

CHIP LEDs, type G0805, Length: 2.0 mm Width: 1.25 mm Height: 1.1 mm Yellow, 590 nm, 3.2 - 8 mcd Beam angle: 120° Coloured diffused housing.

Professional A3 laminator with four silicone rollers and short heating time Reliable lamination for permanent protection against moisture and dirt Four silicone rollers, two of which are heated Heating time: ~40 seconds With automatic device shut-down

Professional A4 laminator with four silicone rollers and short heating time Reliable lamination for permanent protection against moisture and dirt Four silicone rollers, two of which are heated Heating time: ~30 seconds With automatic device shut-down

These magnets are super practical for your home and for the office, allowing you to make creative ideas that seemed impossible a reality. Featuring super-strong neodymium magnets, Novus Dahle MEGA magnets make messages and objects stand out. Geometric sh

CHIP LEDs, type G0603, Length: 1.6 mm Width: 0.8 mm Height: 1.1 mm Yellow, 590 nm, 3.2 - 8 mcd Beam angle: 120° Coloured diffused housing. Manufacturer no.: KP-1608YD

The NA-SAVP1 chromax.yellow set is a fan accessory kit consisting of 16 yellow NA-AVP1 anti-vibration pads for up to 2 compatible 120/140-mm fans. The NA-AVP1 anti-vibration pads are compatible with the following Noctua fans: NF-A14 FLX NF-A14 PWM chromax

For thorough cleaning of all magnetic boards, Magnetic

The NA-SAVP3 chromax.yellow set is a fan accessory kit consisting of 16 yellow NA-AVP3 anti-vibration pads for up to 2 compatible 140-mm round frame fans such as the NF-A15 (see compatibility information). The anti-vibration pads, made from extra-soft sil

• Twin-hole pencil sharpener suitable for thick and thin pencils

KM-23YD-F Yellow SOT-23 Description The Yellow source color devices are made with Gallium Arsenide Phosphide on Gallium Phosphide Yellow Light Emitting Diode. Features: • Yellow (GaAsP/GaP) • Lens Type: Yellow Diffused • SOT-23 package surface mount LED

• Large shavings compartment for longer use before emptying • High-quality steel cutting head for professional results • Sturdy desk clamp for secure attachment to the desk • Automatic sharpening cut-out for a perfect tip • Self-locking pencil retainer wi

SMD Mini PLCC2 reflector LED for all kind of soldering methods usable, especially if customers like to have an LED with metal leadframe, but in a very small housing

Ultra-bright LED, 3 mm, yellow. Coloured housing, transparent. Beam angle: 50° (590 nm)/10 - 50 mcd

CHIP LEDs, type G1206, Length: 3.2 mm Width: 1.6 mm Height: 1.1 mm Yellow, 590 nm, 3.2 - 8 mcd Beam angle: 120° Coloured diffused housing. Manufacturer no.: KP-3216YD

DIN A3 laminator with two heated silicone rollers Reliable lamination for permanent protection against moisture and dirt Two heated silicone rollers Heating time: ~40 seconds With automatic device shut-down after 30 minutes of no use Lamination in photo

• Large shavings compartment for longer use before emptying • High-quality steel cutting head for professional results • Sturdy desk clamp for secure attachment to the desk • Automatic sharpening cut-out for a perfect tip

SMD LED with dome lens, yellow, 568 nm, 300 mcd Clear housing Radiation angle: approx. 50° Dimensions (L x W x H): 3.2 x 1.6 x 1.9mm Manufacturer no.: KPTD-3216SYC

Duo-LED, 3 mm, 2-pin, colour change via polarity reversal. red/yellow Colourless housing, diffused Beam angle: 60° 20 mA 8 - 40 mcd

recessed lampholder with external reflector, chrome-plated ready mounted with yellow 5 mm LED. Incl. washer and nut Features Installation Ø: 8.0 mm Total height: approx. 15.5 mm Reflector head Ø: 9.8 mm Reflector head height: 3.5 mm Wavelength: 590nm