Cable (36)

Ideally suited to applications that require high resistance against environmental influences such as chemicals, gamma radiation, ultraviolet radiation and extreme temperatures. Complies with the requirements of IEEE383. Low smoke and excellent fire resist

Ideally suited to applications that require high resistance against environmental influences such as chemicals, gamma radiation, ultraviolet radiation and extreme temperatures. Complies with the requirements of IEEE383. Low smoke and excellent fire resist

Ideally suited to applications that require high resistance against environmental influences such as chemicals, gamma radiation, ultraviolet radiation and extreme temperatures. Complies with the requirements of IEEE383. Low smoke and excellent fire resist

• Rated voltage: 1000 V CAT III • Rated current: 2 A to 3 6A (with 2,5 mm², fully unrolled) • Cable: 0.75 mm² • Plug: Ø 4 mm • Length: 30 m • Color: red

The BT-BO 25/1 A jump-start cable provides even inexperienced users with excellent assistance when bridging and/or jump-starting petrol and diesel engines. It is equipped with four fully insulated terminal clips. The conductor material consists of 31.4 mm

Accessory set for UTS3000A series - Spectrum Utility Kit NSMAJ-NJ-0.7M DC-6G cable x 1 NJ-NJ-0.7M DC-6G cable x 1 SMA-N-KJ-T DC-6GHz adapter x 2 N-BNC-JK DC-4GHz adapter x 2 2400 MHz-2500 MHz antenna x 2 824-960 MHz/1710-1990 MHz antenna x 2

The BT-BO 16/1 A jump-start cable provides even inexperienced users with excellent assistance when bridging and/or jump-starting petrol engines. It is equipped with four fully insulated terminal clips. The conductor material consists of 19.4 mm² aluminium

• Rated voltage: 250 V CAT II • Rated current: 2 A to 36 A (with 2,5 mm², fully unrolled) • Cable: 1,5 mm² • Plug: Ø 4 mm • Length: 50 m • Color: yellow

shiverpeaks® BASIC-S cable pull-in aid, nylon, 4 mm, 60 m Use the cable pull-in aid to easily pull your cable through a conduit. There is an eyelet on the GRP pull wire. The enclosed wire loop allows you to attach the cable to the eyelet. The screw-on hea

VDV II the universal wiring tester - cloud-connected with Bluetooth and report function for important basic testing to avoid connection problems. The VDI II cable tester is easy to operate and allows the rapid verification of the copper cable of voice, d

shiverpeaks®-BASIC-S--Cable routing aid, nylon, 3 mm, 15 m Use the cable routing aid to pull your cabling through ductwork effortlessly. The nylon pull wire features an eyelet that the cable can be attached to, and a guide spring to make it easier to neg

Accessory set for UTS5000A series 2.92J RF cable (UT-W03-40GHz) x 1 2.92-KKG double socket adapter (UT-C04-40GHz) x 2 MA-N-KJG adapter (UT-C03-18GHz) x 1 Accessory bag (UT-CK02) x 1

The poster pocket is ideal for displaying information outdoors or in damp indoor areas such as in garden centres, saunas or swimming pools in which signs may get splashed with water. Details: Inserts are very well protected thanks to waterproof pressure s

EPA suitable. For working in electrostatically protected areas (ESD workplace/ESD protection zone). For connecting the table and floor coverings and for connection to a ground potential. cable with 1 megohm safety resistor with 2 push buttons 10/10 mm p

• Rated voltage: 1000 V CAT III • Rated current: 2 A to 36 A (with 2,5 mm², fully unrolled) • Cable: 0.75 mm² • Plug: Ø 4 mm • Length: 30 m • Color: blue

EBP-Earth Bonding Point, EPA suitable. For working in electrostatically protected areas (ESD workplace/ESD protection zone). Earthing point for mounting underneath the table top. EBP / Earth Bonding Point = A common connection point to which ESD control e

Earthing measurement cable, 4 mm connection, yellow, 50 m length, with cable reel

ESD discharge cable with integrated resistor. Spiral cable, 2x press-stud 10 mm/10 mm Length: 2.4 m

• Rated voltage: 250 V CAT II • Rated current: 2 A to 36 A (with 2,5 mm², fully unrolled) • Cable: 1,5 mm² • Plug: Ø 4 mm • Length: 50 m • Color: blue

Connecting cable, red/black, angled/straight 4 mm connection, for HIOKI multimeters from product series DT425x/DT428x or similar, CAT III 1000 V, CAT IV 600 V, 120 cm length

ESD discharge cable with integrated resistor. Spiral cable, 3 mm press-stud to 10 mm press-stud Length: 2.4 m

Triple bonded steel connectors for extreme torsion and tensile strength – glued, indented and crimped 5 meters of 100% splinter-proof rods 2 rod flexibilities for overhead, under floor, tight angled and obstructed runs Super tough ‘MIGHTY-FIX’ zinc pla

EPA suitable. For working in electrostatic protected areas (ESD workplace/ESD protection zone). For connecting the table and floor coverings and for connection to an earth potential. with 1 megohm safety resistor 2 push buttons 10 mm for mats or floor co

• Rated voltage: 1000 V CAT III • Rated current: 2 A to 36 A (with 2,5 mm², fully unrolled) • Cable: 1,5 mm² • Plug: Ø 4 mm • Length: 50 m • Color: blue

The Popular Choice – A wide range of rods and accessories for both domestic and commercial installations, this kit is set to become the best seller - 10 meters of 100% splinter-proof rods - 4 rod flexibilities for overhead, under floor, tight angled and o

The Ultimate Cable Rod Kit – The most advanced collection of MightyRods and accessories, cable rod kits don’t come any better than this. - 12 meters of 100% splinter-proof rods for longer cable runs - 4 rod flexibilities for overhead, under floor, tight a

• Rated voltage: 250 V CAT II • Rated current: 2 A to 36 A (with 2,5 mm², fully unrolled) • Cable: 1,5 mm² • Plug: Ø 4 mm • Length: 50 m • Color: red

The poster pocket is ideal for displaying information outdoors or in damp indoor areas such as in garden centres, saunas or swimming pools in which signs may get splashed with water. Details: Inserts are very well protected thanks to waterproof pressure s

This Delock cable support is ideally suited to wall mounting for hanging laboratory cables or test equipment, enabling clear and tidy organisation. Specifications Cable support for wall mounting 2 x mounting holes Mounting hole diameter: approx. 8 mm 1

Ideally suited to applications that require high resistance against environmental influences such as chemicals, gamma radiation, ultraviolet radiation and extreme temperatures. Complies with the requirements of IEEE383. Low smoke and excellent fire resist

This Delock cable support is ideally suited to wall mounting for hanging laboratory cables or test equipment, enabling clear and tidy organisation. Specifications Cable support for wall mounting 2 x mounting holes Mounting hole diameter: approx. 8 mm 1

The ÖLFLEX® CLASSIC 110 is a VDE-registered oil-resistant PVC control cable that can be flexibly used for a variety of applications. Flame-retardant in accordance with IEC 60332-1-2 Excellent chemical resistance Oil-resistant in accordance with DIN EN 5

shiverpeaks®-BASIC-S--Cable routing aid, nylon, 3 mm, 20 m Use the cable routing aid to pull your cabling through ductwork effortlessly. The nylon pull wire features an eyelet that the cable can be attached to, and a guide spring to make it easier to neg

Earthing measurement cable, 4 mm connection, red, 50 m length, with cable reel

shiverpeaks®-BASIC-S--Cable entry aid, nylon, 3 mm, 30m Use the cable entry aid to pull your cabling through ductwork effortlessly. An eyelet is provided on the nylon pull wire to fasten the cable to, and a guide spring to make it easier to negotiate ang

TITANEX H07RN-F 3G1.5, black, wound, in a film bag, tested to VDE 0285-525-2-21 The high-quality H07RN-F cable is ideal for use in moving devices and electrical installations. Its versatile applications range from construction sites to industrial applic